Clayton Power G3 COMBI User Manual

G3 COMBI MODEL: 1012-50, 1024-30, 1312-80, 1512-80, 1524-40, 2012-100, 2324-50

3.0 Device layout Auxiliary LED Description Pos. Color Function A Green Lights when Data link is “High” B Yellow Lights when Da

Pin 1 Phoenix Combicon Pin 1 3.1 External connections RJ12 type 6p6 connector: 1 Pin# Signal Description 1 - TEMPX1 Reserved for fut

3.2 External Wiring  -TEMPX1 1 User GND 2 +TEMPX1 3 SYNC_IN/OUT 4 DATA 5 REMOTE 6 1 2 3 4 5 6 External NTC Vishay 2381 640 63102 1K NTC Sin

Housing Insert Chuck Bushing 3.3 Neutrik connectors as

4.0 Accessories 5.0 Operating the device •The aim of this section is to give a brief overview necessary to operate the device and give some pr

Charger section: Charge current adjust • The charge current can be adjusted by the potentiometer on the front panel top from 0A up to maximum r

Errors charger: AC input voltage to low <185VAC (with inverter switched ON) • 1 flash by green LED Note: If the inverter is switched OFF, the c

5.1 Load search mode • In cases where it is preferable to leave the combi switched on, and the load is periodically inactive (swit

5.2 Charge Current Setting • Recommended battery capacity versus charging currents (at 20°C battery temperature) Charge Current Recommended Batter

5.3 Charging Stages • The charger is a fully automatic 3-stage charger with IUoUo characteristic. Boost charge - Fast flashing green LED • The charg

6.0 LED codes description • The Blue LED is for the Inverter section. • Green LED is for the charger section. • Red LED indicating the status of

7.0 Batteries WARNING! Workingwithbatteriesisdangerous!Batteriesgenerateexplosivegasses!•Thereforeitisofoutmostimportancethateach

7.1 Maintenance batteries • Performing preventive maintenance on batteries is easy and should occur at least once a month during hot weather and eve

8.0 Warranty • Installation, operation, technical support, warranty and service issues should, in the first case be directed towards

Table of content 1.0 System specification Electrical specification inverter Mechanical specifications General features a. Mechanical dimension

Electrical Specification InverterMODEL 1012 1312 1512 2012 1024 1524 2324 2336POWER RATINGContinuous output power FTS (Full Temperature Scale) 1000W 1

Electrical Specification InverterMODEL 1012 1312 1512 2012 1024 1524 2324 2336POWER RATINGContinuous output power FTS (Full Temperature Scale) 1000W 1

1.1 Mechanical Dimensions Model: 1512-80 2012-100 2324-50

1.2 Mechanical Dimensions Model: 1012-50 1024-30 1312-80 1524-40

2.0 Installation Environment • The inverter (or combi) must be placed in a dry, well ventilated and dust free location. • Place the unit as close

Mounting DC cables • PAY ATTENTION TO CORRECT POLARITY! • Check that the battery voltage matches the DC input to the inverter (or combi). • Check